According to my diagram there is a white wire that goes from the ignition
switch to the amp gauge and another one that goes to the heater switch so it
sounds like you are on the right track.
Carl
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Andrew Uprichard
Sent: Saturday, December 15, 2012 6:49 PM
To: 'Triumphs'
Subject: [TR] rewiring a TR3
I should probably know this, but as part of the center dash cluster wires, I
have a single white wire. It is not the wire for the ignition switch nor
light. Any suggestions? Could it be a live feed for the heater rheostat?
I would have thought that should be a green (post-fuse) wire, but I have run
out of wires from the loom and that is the only switch left remaining.
Bear in mind that I am reusing an old harness which had undergone
"modifications" in the past. It's great fun guessing what wire should be
used for each indication when several have been spliced and replaced with
teh wrong colors !!
Andrew Uprichard
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/cfmtr3a@verizon.net
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|