I haven't been following this thread from the beginning so I don't know if
this has been mentioned but Z Therapy used to do roller throttle shafts with
rubber seals for most models of SU carbs. I haven't used them myself but have
seen their work and it looks good.
http://www.ztherapy.com/
Doug
Date: Sun, 11 Nov 2012 16:42:18 -0800
From: "Randall" <TR3driver@ca.rr.com>
To: "'Triumphs'" <triumphs@autox.team.net>
Subject: Re: [TR] TR3 carb bushings
> What they don't tell you is that the new shafts are not drilled for the
> pins that locate the throttle stops.
I forgot to mention: Drill for the pins _before_ you cut the shaft to
length. That way, if you goof, you can turn the shaft end-to-end and try
again. The extra hole will be hidden under the spring, and won't hurt
anything. Don't forget to deburr the hole (both sides) before doing a trial
fitting.
Randall
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|