I converted wrong the feeler gauge I had is only marked metric. It was
.040.
Roger
On 07/26/2012 11:44 AM, Roger Elliott wrote:
Hi,
I have a question about valves going out of adjustment.
Recently, I adjusted the valves on my Spitfire (two of the valves were
way out of adjustment- too large of a gap). I then took it in to a
shop as I could not get it to run quite right. I asked them to adjust
the carbs as I thought that was the problem.
Well in the process of dong that, he discovered that some of the
valves were way out of adjustment. Okay I might have messed up some,
but he said they were about .1.
Now I was changing the oil and I wanted to check the rocker assembly
as I thought perhaps it was loose and allowing the gap to get
larger. All of the nuts were tight.
But I looked at a couple of the valves and they are probably about .1
again.
It looks like the adjusters on the valves that have the big gap don't
have as much of the adjusting screw sticking out the top as the others.
What could be causing my gap to increase so much?
I recently put in new tappets that were tested for hardness.
Thanks,
Roger Elliott
1980 Spitfire
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/elliottr@rmi.net
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/triumphs-archive@autox.team.net
|