triumphs
[Top] [All Lists]

[TR] TR 2/3 fan/alternator belts.

Subject: [TR] TR 2/3 fan/alternator belts.
From: guy at genfiniti.com (G.D. Huggins)
Date: Wed, 16 Nov 2011 13:01:01 -0600
References: <4EC3F24B.50506@execulink.com>
Angelo,

I've been wrestling with this one myself for a while.
I converted to an AC Delco 7127, with a large pulley so I would not have to
change the crank or water pump pulley to a more narrow dimension.

The thing to bear in mind is that a belt IS NOT supposed to bottom out in the
pulleys.  Only the sides of the belt should make contact.
If the belt does bottom out in a pulley, it will make a god-awful whining
sound that gets louder as RPMs go up.

I am using a Gates TR28390.  It was a tight fit going on (had to loosen the
mounting bolt to the point where I could cheat the alternator toward the belt
to get it to slip over the pulley), but seems to be doing well.

Best of luck!!



On Nov 16, 2011, at 11:26 AM, Angelo Graham wrote:

> Hello List:
> Have an alternator conversion on my TR2 and have struggled with the fan belt
since installing the alternator. I have used a Gates TR24379 which is a 3/4"
belt, 38 3/8" long. Impossible tight fit and a bear to try to get on or off.
The next Gates belt in this series (Truck/bus Green Stripe) is 40 5/8" and is
too long. Searching the Gates site and found a series of 7/8" belts that would
seem to do the job at 39 1/8" - which is listed by Gates as the "stock" belt
for the TR2/3/4 series - TR28386 (Green Stripe).
> Can we use a 7/8" belt on our pulleys? Always thought that the belts were
supposed to be 3/4" - not worry about it and use it if it fits??
> Thanks for any help with this one.
> Angelo Graham
>
>
> triumphs at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/guy at genfiniti.com

<Prev in Thread] Current Thread [Next in Thread>