I guess the purely pragmatic part of me says, since nothing else worked and
it seems to have cured the problem, I'd go with it (especially since you
have reason to believe "work had been done on the fork").
Andrew Uprichard
-----Original Message-----
From: triumphs-bounces at autox.team.net
[mailto:triumphs-bounces at autox.team.net] On Behalf Of
thenicholls at verizon.net
Sent: Sunday, September 18, 2011 2:33 PM
To: triumphs at autox.team.net
Subject: Re: [TR] 1972 Triumph TR6 Clutch Master cylinder leaking - Followup
installation question
To the list,
Installed the new clutch master cylinder purchased from a local British car
shop. They will only use TRW.
My friend (who owns a Jag) came over after I had it installed to help me
bleed. That got taken care of, no problem.
However, when I went to bring the car off of the ramps, I could not even get
it into gear. So, we did the usual, we bled again and did exactly how the
book describes it, we pumped and shut the bleeder when the pedal was
depressed.
Still, could not get it into gear, My Jag friend said there must be an
adjustment, I advised him that originally there was not. However, you have
the three holes where the lever can be placed to have the slave move the arm
for the gear box. It was in the middle as is specified.
So, we tried the bottom hole, same thing. We then placed it in the top
hole, in gear no problem, took a test drive, no problem.
Since all the clutch master cylinders are the same except for the bore being
.7 or .75, could anyone explain why this would happen? And, most
importantly, is there any issue with leaving the slave attached to the top
hole?
Just for reference, when I bought the TR from the original owner 6 years
ago, when it was inspected at the local British car shop, they had stated
that some work had been done on the fork and that the clutch would need to
be replaced at some point. Well, the original is still in there with no
issues.
Any insight on this would be appreciated.
Craig
1972 Triumph TR6
Vienna, VA
From:
Sent: Monday, September 12, 2011 6:54 PM
To:
Subject: [TR] 1972 Triumph TR6 Clutch Master cylinder leaking
> Already been down this road once.
>
> Replaced clutch master with a Girling purchased from TRF 6/22/07. Well, I
> guess I should say I got 4 good years. It is now leaking on the inside of
> the car. I have a really nice paper towel wrapped around it.
>
> Does anyone on the list have any recommendations for a clutch master brand
> that will actually last? I read lots of bad stuff in the archive, and the
> comment from the British car shop that replaced it before said "anything
> in a white box is trouble".
>
> Suggestions?
>
> Thanks,
>
> Craig
> Vienna, VA
>
>
> triumphs at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/sumton at sbcglobal.net
triumphs at autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/auprichard at uprichard.net
|