Hi Everyone,
When we were leaving Breckenridge after the VTR, the mi wife's 250 was running
very poorly. We discovered that a plug in the rear carb was missing. The
front carb has a port on top that goes to the distributor - not sure if it is
vacuum or retard. The rear carb has the same hole, but there was nothing in
it. It must have fallen out somehow.
I tried a pipe threaded plug that was close but not right (I don't remember the
size). So we ended up using a rubber plug in the hole.
Does anyone know what size of plug I would need? Is it something I can find at
a hardware store? I could not find the part at any of the usual places.
Thanks,
Roger Elliott
|