triumphs
[Top] [All Lists]

Re: [TR] tr6 reversing woes

To: "'Frank Fisher'" <yellowtr3@yahoo.com>
Subject: Re: [TR] tr6 reversing woes
From: "Randall" <tr3driver@ca.rr.com>
Date: Thu, 14 Jul 2011 16:50:09 -0700
> If the electrics are proven not to be
> the problem and banging on the brake ring with a BFH does free the
> clutch,
> I'd invest in a pressure gauge and run a pressure check before going
> any further.

Good idea!  In addition, I suggest doing at least one check at high speed
with the gearbox relatively cold.  I apparently had my A-type accumulator
shimmed up to the point where it would regulate the pressure just fine at
low rpm, but get coil bind and let the pressure soar at high rpm.  Since I
only did a pressure test on the bench at around 800 rpm, I didn't realize
the problem until after it had done some substantial damage inside the unit.

In my case, the clutch didn't stick, but the force bent the bridge bars for
the operating cylinders and bent the big circlip that holds the clutch ring
to the carrier.  I think it's also responsible for the broken thrust washer
that finally disabled the unit.

-- Randall 


triumphs@autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>