I have started to install all new tail light hardware on my tr3a. I find
that each light fixture has a place to attach a bullet end ground wire. My
new wiring harness does not have a ground wire for these lights and the
wiring diagram I have does not show an actual wire going to a ground. I
assume that all are grounded through the screws that attach the fixture to
the body. The hardware that I removed did not have ground wires. The
question is; Should I run a ground wire to each light? Why is there a
place on the fixture to ground it if it was not supposed to be used?
George Murphy 1960 TR3A - Waleska, Georgia
_______________________________________
No infections found in this outgoing message
Scanned by iolo System Shield.
http://www.iolo.com
|