Dave - just went through this myself.
According to the parts catalog (don't ask me where I found it - it was buried)
there is a metal bullet connector which fastens somewhere on the shock
tower/horn support. P/N 236366A. When I asked where it goes, Randall
suggested to just install ground leads from the horn mount to somewhere closer
to the lamps. Would make it easier for r/r later. I haven't gotten back in
there to finish the job so don't know how I'll end up doing it. The clips
are available (if you go that route) from TRF - or - I ordered a pair but found
another two in the parts pile so let me know and we can work out something
(donation to team.net)
Yes on the wiper motor. it mounts under the left front leg of the support
bracket.
C
Yes
Jun 6, 2011 12:27:07 PM, dwillner at ptd.net wrote:
Replaced the harness yesterday, and have the majority of connections in place,
couple questions regarding the headlights and front turn signals/parking
lights. The headlight harness have "blue/white" and "blue/red" colors which I
believe snap into the triple connectors of the same color on the main harness,
there is also a black ground wire, do they ground to the frame "screw" in back
on the horns?
Also, on the front blinkers the "green/white" and "green/red" wires snap into
the double connectors with the same colors I believe, and the red wire snaps
into the red on the main harness "triple connector," correct? There is also a
black ground wire and I'm not sure where that connects on the Lucas bulb
holder, and does that too ground to the screw in back of the horns? Are there 3
bullet connectors on the front bulb holders?
On the wiper motor, E = ground (black), 1 = black/green, 2 = green, correct?
There is also a separate black wire with an eyelet close to these three, does
that ground under the wiper motor bracket (seems familiar)...
Appreciate the help, may have a few more...
Dave Willner
Stroudsburg PA
59 TR3A
70 MGB
70 BSA 441 VS
|