Is it the pivot or the shoulder bolt? You could always have a machine
shop drill out the pivot and bush it for you. It wouldn't take them any time
and should be fairly cheap. You can also check with Joe Curto for parts.
Sam Clark
Green Country Triumphs
In a message dated 6/15/2011 12:01:08 A.M. Central Daylight Time,
pdonnel1@san.rr.com writes:
In looking at the linkage on my HS6 setup, I find that the bracket between
the carbs has a worn screw-hole for the pivot screw. This induces some slop
in the accelerator travel, and I'd like to reduce that slop.
Does anybody make a replacement bracket? They're not available by the big
3.
Has anybody put another option into play, like a cable pull arrangement?
Thank!
Johnnie
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/triumphs/trdoctor@aol.com
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|