First question, is the leak grease or gear oil? If it is gear oil, then it
is the inner seal that is leaking, and it does not take a hub puller to
replace it.
If it is grease, then most likely the bearing has been over-greased and the
leak will stop if you stop greasing the bearing so much. There is a TSB
that warns about this.
Haven't made a hub puller myself yet ... well, more accurately I haven't
made one that works every time <G>
However, I've put a couple of documents up at
http://tinyurl.com/56gylc
that others have written. Look for "Tony Gordon Rear Hub rebuild notes plus
blueprint" for a drawing of the original Churchill tool; and "TR3 Rear Axle
and Hub Separator" for a variation on the theme.
-- Randall
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|