--===============1853111910==
Content-Type: multipart/alternative; boundary=0016e6da9342b245d304a4d2a9fd
--0016e6da9342b245d304a4d2a9fd
Content-Type: text/plain; charset=ISO-8859-1
I'm in the midst of this too -- my plan (unless I am talked out of it) is to
use the Ultra Copper Goo from Permatex on the pan letting it set whilst
upside down on a perfectly flat surface. Then use Hylomar between the
gasket and the block.
If the copper stuff proves to be a bugger to remove at least I'll be working
on the pan & on the bench, not under the car looking up.
--0016e6da9342b245d304a4d2a9fd
Content-Type: text/html; charset=ISO-8859-1
Content-Transfer-Encoding: quoted-printable
<div>I'm in the midst of this too -- my plan (unless I am talked out of=
it) is to use the Ultra Copper Goo from Permatex on the pan letting it set=
whilst upside down on a perfectly flat surface.=A0 Then use Hylomar betwee=
n the gasket and the block.</div>
<div>=A0</div>
<div>If the copper stuff proves to be a bugger to remove at least I'll =
be working on the pan & on the bench, not under the car looking up.</di=
v>
--0016e6da9342b245d304a4d2a9fd--
--===============1853111910==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
--===============1853111910==--
|