In a message dated 2/7/2011 7:55:51 AM Central Standard Time,
guy at genfiniti.com writes:
> However, even if you tighten the nut to the end of the threads, there is
> still a lot of free-play because of the length of the vertical shaft.
> How do you take out this free play?
> Is there supposed to be some sort of spacers?
> Do the hard tubes stabilize the wheel housings once they are added?
>
There are two spacers for the shaft, one on either side of the sheet metal.
Since the shaft is not at a right angle to the sheet metal (it is at a
right angle to the windscreen) the spacers are cut at a bevel to set it
properly. If you are missing the spacers that go underneath you will not get
them
to tighten up.
This page from the Roadster Factory TR6 parts catalog shows it pretty well.
http://trf.zeni.net/TR6-250GC/153.php?s_wt=1280&s_ht=1024
Dave
|