My to be rolling chassis commission # is CT26535, I plan on using parts from a
commission # CT5908 for the front end suspension .
I intended on rebuilding the entire front suspension using parts exclusively
from the Ct5908 commission car.
Q1: Will there be any problem mating up assembled front suspension to the later
commission chassis?
Q2: When ordering replacement parts, I presume I should order them based upon
the earlier commission #?
Q3: Could I utilize (If I was consistent ) utilize the replacement parts for
the later commission #? (ie ball joints and control arms)
Thank you
Peter
551.427.1178
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|