In this case - a picture is worth more than a few words - not sure if a
thousand could be said....
Anyway, thanks - it does confirm my vague recollection. Is the hole you are
speaking of on the curved section of the door pressing right at the upper hinge
mount? That is the only hole I see.
Thanks again - this list is great. of course now I need to find the
connecting pieces, the springs, and the fitting that clamps onto the cable. Is
it the same as the vent-lid pull? - looks very similar.
Dec 4, 2010 09:14:49 PM, wbeech@flash.net wrote:
Will this help?
A & B) Hope the picture helps
C) On the front inside of the door you should find a little hole that the
cable goes through. I would run the cable in such a way that the ball is on
that end.
All the best,
Bill
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|