On Monday, October 25, 2010 01:02:10 pm Carl TR wrote:
> I won some gift certificates for powder coating at the All British Show
> here in Safety Harbor this past weekend.
>
> I decided to take my heater unit (dismantled) to be done.
> Bottom cover/doors in wrinkle finish everything else except the silverish
> piece in semi-gloss black.
>
> The question is whether the coil itself should be powder coated or remain
> 'au natural'? He can do the top and bottom plate and mask off the coil
> (inside & out). However, the guy at the shop said there shouldn't be any
> problem with PC'g it and it would in fact increase the 'insulation'
> factor. I couldn't decide if that is good or bad.
>
> Advice?
>
> Thanks
> Carl
>
Carl,
Since I am not a PC expert, will the heat to bake the paint cause a problem
with the solder used on the heater core?
Bob
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|