List
I know this has been discussed before, but I will admit to not having paid
much attention as it was not relevant at time . . .
It is time for me to get the OD trans installed in my TR3.
I have heard all sorts of horror stories about different clutch/pressure
plate/ TO bearing manufacturers. As I REALLY don't want to pull the tranny
more than once, what is the recommended setup? Sources for the recommended
parts?
Also, I understand that it is recommended to put in a hardened pin in the
clutch release mechanism. Any suggestions there?
All suggestions or comments appreciated.
Thanks
Alex
1958 TR3 TS33884LO
1968 GT6 KC10303
1976 TR6 CF51981U
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|