> When rebuilding the engine for the '3 project, I used a plug
> in the breather pipe block hole. Forgot to pull it out before installing
the
> engine.
What about a long punch/chisel, at an angle; then pry it out?
Or, making an extra-short bit to go in the angle drive? For just one
shallow hole, you could grind a broken drill shank into a spade bit fairly
easily I think. No need for flutes or a fancy cutting tip; just grind in
from the sides to create a flat end, then put a couple of cutting lips on
it. Kind of like this
http://en.wikipedia.org/wiki/File:Drill_spade_tiny.jpg
except I was thinking more like 1/8" or so.
You can also buy stubby bits to go in one of these:
http://www.youtube.com/watch?v=pGiEuNqX3_g
Randall
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|
