Gary
0.254mm is equal to 0.010 inches
frank
________________________________
From: Gary Nafziger <nafzigerg@yahoo.com>
To:
triumphs@autox.team.net
Sent: Fri, September 17, 2010 2:20:13 PM
Subject: [TR]
main/rod bearings
taking apart tr-3 motor. found that big end rod bearings
are .010 over. taking
off the main bearing front and rear bearing/seal I
find no notation of .010 but
do find the number 0.254 MM above it another
number that i think is a part
number.
just curious. I'm assuming that the
main bearings are standard even though
there is not a "standard" marking on
the bearings. surely they aren't 0.254 mm
over? Is it normal to go over on
the rod bearings and leave the main bearings
standard?
thanks
gary n.
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/triumphs/yellowtr3@yahoo.com
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|