Bob,
I thought about that but was afraid the whole can would come apart. What
type of solder and heat source did you use?
Bill
Bill Beecher
'58 TR-3A TS30766L "Tarbaby"
www.triumphowners.com/1566
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Bob
Sent: Sunday, August 22, 2010 10:36 AM
To: triumphs@autox.team.net
Cc: Joe DeMuth
Subject: Re: [TR] Brake Fluid Reservoir
On Saturday, August 21, 2010 03:32:09 pm Joe DeMuth wrote:
> List, has anybody refurbished a TR3 brake fluid reservoir? I've got
> one apart, I was surprised it came apart. The can looks good but it
> leaked past the fittings on the bottom. It appears that the aluminum
> washers have given up the fight. Could I use copper washers instead?
> Also, there is a large (1 inch OD) washer on the brake side, inside
> the can, but the clutch chamber did not have a washer. Does it just
> seal to the bottom inside of the can using its rim as a washer. Seems
> a bit iffy. I was thinking of putting a washer there, also. Any help/
> ideas/advice is appreciated.
>
> _______________________________________________
Joe,
I replaced the aluminum washers with copper many years ago and then soldered
the whole bottom. I can never see a need to see the need to ever take it
apart and so far in over 30 years of ownership, I was correct.
Bob
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|