I'm in the process of removing the shortened (for wire wheel) studs on
the rear hubs of my TR4 and replacing them with the disc wheel studs.
I've managed to get the studs out of the hub and have threaded the
replacement studs in place. The question is what is the best way to
peen the ends of the studs over?
The factory obviously did this with some sort of press. Since I don't
have something like that handy I'm looking for ideas on the best way
to proceed.
Anyone been there done that?
Thanks!
Brad
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|