Hi List!
I just received my two digests at 20:00 & have read through the replies.
Jim, I have a suggestion that might solve your problem:
Go to a good hydraulic place that will make up lines for you & sell you
different fittings. Then simply purchase a fitting that will convert to metric
to Standard (3/8" x 24T) on the threads. It would be a LOT CHEAPER than
purchasing a new part. The part may just be the cost of what shipping the part
would be, not counting the cost of the part.
-Cosmo Kramer
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|