I'm not finding the adapter on Moss's site, but one thing that I've
not seen mentioned - there are two basic designs of the oil cooler
adapter that I've seen. One goes between the block and the filter
"housing", and the 2nd goes between the oil filter itself and the
filter "housing" - or in my case, replaces the filter completely. My
understanding is that the one that sandwiches between the filter
housing and the block sends the oil pressure before the relief valve
to the cooler while the one that attaches where the filter would go
sends the AFTER relief valve pressure to the cooler. The oil pump
puts out quite a bit of pressure so you are more apt to split the
cooler with the higher pressure setup.
- Tony Drews
At 12:44 PM 6/9/2010, Chris Simo wrote:
>I see that Moss has a straight through adaptor (looks like a 1 inch thick
>cylinder with a filter adaptor) and Vicky Brit offers a 90 degree adaptor
>- Are there advantages to a 90 degree mount?
>
>Chris
>
>_______________________________________________
>Triumphs@autox.team.net
>Donate: http://www.team.net/donate.html
>Suggested annual donation $11.47
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe: http://autox.team.net/mailman/options/triumphs/tony@tonydrews.com
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|