Am trial fitting body components on RATCO chassis and have a general question
concerning the placement of the body mounting pads on the four frame
outriggers that accept the inner sills and floor pans. The parts book shows
up to 4 pads at each location and am wondering what has worked for others, and
the sequence you used. IE, did you mount the pads to the outriggers and then
attach the sill with no pad between the sill mount and the floor, or mount
sill directly to outriggers and pads between sill and floor, etc. Any advise
or past experience appreciated. Have also noted that the reproduction rear
(sloped pre 60,000) floor panel is about 1/2" shy of meeting the inner sill on
the RHS. Am thinking I should wait to deter min a remedy till the tub with
inner fenders intact is placed over it.
Dan
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|