After a few years my front suspension creaks a lot after installing the poly
bushings. The rears are quiet. Any ideas to quieten it?
Johnnie
TR4A
> -----Original Message-----
> From: triumphs-bounces@autox.team.net [mailto:triumphs-
> bounces@autox.team.net] On Behalf Of Mark J Bradakis
> Sent: Saturday, December 05, 2009 11:59 PM
> To: 6pack@autox.team.net; triumphs@autox.team.net
> Subject: Re: [TR] installing rubber suspension bushings
>
> I've often used a length of threaded rod and stacks of large washers
> to pull bushings into place as the nuts are tightened. You don't have
> to use a rod that goes all the way through both bushings, a bolt of
> the appropriate length can work on one at a time.
>
> Lubrication helps a lot. I've used WD-40, white lithium grease,
> emulsified hand cleaner ( not the kind with pumice or other grit! )
> and Girling rubber grease at one time or another.
>
> mjb.
>
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|