Hello List:
Noticed after installing a new pinion seal on my Girling axle that
the seal seemed to have a lot of drag on the pinion shaft. It is a
new, modern seal sourced from the big 3, but it was very tight and
now I can notice a real drag on the shaft when I turn the drive shaft
flange. Is this to be expected? We used lots of lube to install the
seal and it was a tight fit.
Worried about eventually wearing a grove in the pinion shaft -
Speedi-sleeve time again.
Any insights??
Thanks in advance for any advice on this.
Angelo Graham
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|