I followed the method in the VTR maintenance section, except I used Permatex
to bond the gasket to the pan, left to set overnight. I then used Hylomar on
the gasket-to-block face so that I could easily get the pan off again and
had no risk of goop in the pan causing mischief.
I took care to straighten the pan lip first. My pan had been heavily
over-tightened by the DPO and his answer was to use masses of orange rubbery
goop to close the gaps on the distorted pan lip. He failed. The VTR page:
http://www.vtr.org/maintain/oil-pan-gasket.shtml
Brian Jones
On Tue, Oct 27, 2009 at 8:51 PM, Tony Drews <tony@tonydrews.com> wrote:
> That's what I use as well. Permatex brand is what the local Farm and Fleet
> carries. I still leave a trail of oil, but not from the oil pan flange.
>
> - Tony Drews
>
> At 01:57 PM 10/27/2009, STEVE STERN wrote:
>
>> Subject: Re: [TR] Oil Pan Leak
>>
>> "I cured my oil pan leaks by installing the gasket with black RTV. This is
>> a
>> silicone gasket maker. I only used the RTV on the area outside of the bolt
>> holes to prevent it from getting into my oil system. No more leaks."
>>
>> I second it! I've been using RTV adhesive and/or gasket maker on all paper
>> and
>> cork gaskets since the 70s without a leak.
>>
>>
>> Steve
>>
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|