Re: [TR] Question about shimming the distributor pedistal on a TR4A

["Randall" <tr3driver@ca.rr.com>]

> Actually, I can't remember removing any when I took it apart.

Which very likely means you don't need any.  Most of them don't, by now,
unless someone has replaced the bushing in the block.

The SPC implies that "gaskets" (P/N 125251) are to be used to adjust the end
float.  TRF has them listed for $.75 (or you could certainly make your own).

-- Randall  
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive