How about some heat shrink tubing, on the threads and nut?
In a message dated 10/12/2009 9:54:45 P.M. Eastern Daylight Time,
acekraut11@aol.com writ
I am thinking about trying to seal up the treads on the mounting studs
for the front side lamps for early '74 TR6 so that next time I remove them
they don't snap off from being rusty. I plan to us a SS nyloc nut and some
anti-seize. There are still a lot of threads exposed in the wheel well.
How do
you prevent them from rusting? Paint? Undercoat? grease & some sort of
tape or
sleeve?
TIA,
Bill in Tehachapi
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|