I used epoxy to glue the glazing to the glass (trim at the corners) and then
a lot of soap and water to get it into the frame.
Andrew
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Scott Suhring
Sent: Wednesday, September 30, 2009 6:46 AM
To: Triumph Mail List
Subject: [TR] TR3 Windscreen glazing
I am curious if there is any advice on best to install the rubber glazing
around the windscreen and fitting this into the frame. Seems like a tight
fit. TIA
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|