I've had good luck just holding the Plexiglas over a red-hot element on our
electric stove till it was pliable enough. Easy to re-do if it needs a
little more (or less) bend, and you can control the heat by the distance
form the element.
Karl
> Since you've raised the topic, what is the easiest way for a total novice
> to
> go about putting some mild bends in some 3/16" Plexiglas?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|