it keeps the bracket from flexing.
Ray
----- Original Message -----
From: "Tony Drews" <tony@tonydrews.com>
To: "Glenn Owen" <mgowen55@hotmail.com>; "Triumph Mailing List"
<triumphs@autox.team.net>
Sent: Tuesday, June 16, 2009 10:15 PM
Subject: Re: [TR] TR4 Slave Cylinder Stay Rod
>I don't have one on my race TR-4 and have had no issues. So, it's not an
>URGENT addition. I think it's not a bad idea to have one, though.
>
> - Tony Drews
>
> At 04:11 PM 6/16/2009, Glenn Owen wrote:
>>My 67 TR4A is not fitted with the stay rod that runs from the oil pan bolt
>>to
>>the clutch slave cylinder mounting hole. I assume it was discarded long
>>ago by
>>some mechanic as a matter of convenience. Is it safe to operate the car
>>without the rod or am I risking some sort of catastrophic failure if I
>>don't
>>replace it?
>>Thanks
>>
>>Glenn
>>67 TR4A CTC76828LO
>>_______________________________________________
>>
>>Support Team.Net http://www.team.net/donate.html
>>
>>This list supported in part by the Vintage Triumph Register
>>http://www.vtr.org
>>
>>
>>Triumphs@autox.team.net
>>http://autox.team.net/mailman/listinfo/triumphs
>>
>>You are subscribed as tony@tonydrews.com
>>
>>http://www.team.net/archive
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as spook01@comcast.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|