On Sat, May 23, 2009 at 9:15 AM, Eric Bartleson <ebartle@hbci.com> wrote:
> I need assistance installing the grab bar in my TR3A. It appears
> that if mounted it will block the glove box from opening.
Assuming you have the correct grab bar and that you have located the holes &
captive nuts in the scuttle then it owould seem the problem may be that the
sheet metal dash is mounted too high into the scuttle.
How much clearance do you have between the top of the cubby-box door and the
lower edge of the rail? Should be about 3/8" (I think) when a
leather-covered rail is installed.
As I recall, there is some adjustment provided for (slotted holes?) in the
mounting of the dash.
Geo
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|