Hello List,
I bought the complete locks & handles kit from Moss and everything was going
fine until I tried to replace the tumbler in the ignition switch. I poked a
screwdriver into the little hole and removed the old tumbler, the spring pin
was pretty shot, but the new tumbler will not go in all the way as the
spring pin seems to be preventing it from sliding into place.
Is there any way to retract the spring pin while you insert the tumbler then
release once it is in place?
Thanks,
Bill Beecher
'58 TR-3A TS/30766 L (On the road in 2009!)
'59 TR-3A TS/64974 LO (in buckets, for sale... anyone?)
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|