> Does anybody know of a source for the gasket alone? Or a workaround?
Although I have not tried it, I believe an O-ring of suitable dimensions and
material should work.
However, at least a TR3 cap has a deliberate vent hole that is only a
fraction of an inch higher than that gasket, so I'm not sure that replacing
the gasket is going to solve the problem. Even without the vent hole,
certainly the center post is not fuel-tight. There is also the issue of the
tank vent, which is lower than the gasket.
So, perhaps the correct solution is to not fill the tank so full.
-- Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|