Gary: I installed it about a year ago, and am very happy with it. A very
noticeable improvement in power on the first test ride, even before the
linkage was completely sorted out. Now it really pulls so much harder than
the 2-carb setup. Speaking of linkage, if you do decide to do the
installation, definitely consider converting to the Ratco linkage (at least,
for the ZS carbs). It was almost impossible to get full throttle with the
original monkey-motion linkage no matter how I lengthened, adjusted, changed
angles, etc.
I think you'll like it.
I should add that our TR also has an Isky street cam, headers and mild
compression boost (from '76 low comp.). Before the conversion, the power
tailed off rapidly after ~4500rpm. Now I can run it up to redline if I want.
Tom
----- Original Message -----
From: "Gary Nafziger" <nafzigerg@yahoo.com>
To: <triumphs@autox.team.net>
Sent: Friday, April 24, 2009 8:10 PM
Subject: [TR] Good tri-carb manifold?
> Speaking of Good products has anyone installed the Good tri-carb inlet
> manifold........adding another carb? I'm thinking of getting one for the
> TR-6. Wondering if those who have installed one are happy with it?
> Noticable
> increase in power?
>
> thanks!
>
> gary n.
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as tom628@verizon.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|