As I posted earlier I installed an alloy valve cover with the non breather
cap, and discussed the resulting oil coming from the lower breather tube.
I have solved the problem (maybe) by getting a 3/4" washer that is 2" in
diameter and soldering a 1 1/2" OD chrome over brass tail piece from a sink.
There is grinding and fitting to get it just right, and I have yet to
make the rubber gasket, but check out the pics. Yes, there is enough bonnet
clearance and now I have a breather cap.
_http://i215.photobucket.com/albums/cc88/TRG69/P4220375.jpg_
(http://i215.photobucket.com/albums/cc88/TRG69/P4220375.jpg)
_http://i215.photobucket.com/albums/cc88/TRG69/P4220376.jpg_
(http://i215.photobucket.com/albums/cc88/TRG69/P4220376.jpg)
It is not yet in service as I am rebushing my rockers. More to come.
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
**************Big savings on Dell XPS Laptops and Desktops!
(http://pr.atwola.com/promoclk/100126575x1220433404x1201394533/aol?redir=http:%2F%2Fad.doubl
eclick.net%2Fclk%3B214133109%3B36002181%3Bk)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|
