>Terry, my suggestion is to use a drift through the center of the hub to tap
>the inner race of the inner bearing out, which will knock the dust seal out
>with it. B You can then clean and grease the bearing properly.
Thanks, Randall.B I couldn't remember how I assembed it during the rebuild.B
I sorta remembered it was pressed in, but then I can't seem to remember much
of anything anymore.
Terry
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|