In a message dated 2/11/2009 8:48:27 A.M. Pacific Standard Time,
tr3driver@ca.rr.com writes:
I've been wondering about that. Some simple experiments with original
Triumph gears seem to indicate that they are not case hardened. In fact,
they aren't very hard at all. Compared to say, a cheap socket, they cut
quite easily. So I would guess that they are only heat treated and left at
a moderate temper.
Randall
I have designed and manufactured gears for gearboxes and final drives in
industrial equipment, (sometimes more successfully than others!)
There is a big decision point issue regarding surface hardening or not as
this is a big cost driver.
When I can, I prefer to through harden to 38 Rc if possible, and not surface
harden. Bad things can happen when you surface harden (cracking,
insufficient case depth, distortion etc.) You're also doing this because
something is
stressed highly enough that wear is an issue.
I once watched some Harley Davidson gears being cut through hardened to 58C
using a Japanese $2M gear cutter. These were very high precision high speed
gears.
If you surface harden, you usually need to worry about surface accuracy and
I have had to have gears ground to retain the accuracy. Some methods distort
more than others, some methods promote cracking more than others.
Through hardening to too high a level can also cause the material to become
brittle. I once made a gearset of 440C stainless steel (55 Rc through) and
they broke up due to shock loading, even though we never approached the yield
strength. We later referred to them as the 'glass gears"!
Cost is a big issue, and the designer has to look at all the alternatives,
such as material choice, design, methods of manufacture, tooling etc. etc.
I once saw some gears in San Diego being cut out of a stack of plywood glued
together! I have no idea what his application was, but he could have had
steel or aluminum for almostthe same price as he was paying for machine time.
Mike Moore
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|