Hi Bill,
I just had the same problem as you did from my TRF kit. I ended up sending the
kit back because of the lack of material I needed to do a excellent job. If
you have the old pieces that are still intact, you can use it as a pattern for
the new material.
I ended up ordering the vinyl by the yard that matches exactly the same grain
and material. It gave me extra material that I could use on some worn windlace
pieces that were done in vinyl.
Ibsen
'59 TR3A, '71 TR6 , '79 Spit
----- Original Message -----
From: Bill Beecher
To: 'list Triumph'
Sent: Friday, January 16, 2009 1:21 PM
Subject: [TR] TR3 Dash Covering Kit
I got my vinyl dash kit from TRF last week and got around this week to
putting it on.
First of all, the width of the vinyl was less than 8.5" in some place
around
the glove box area and this made for a VERY tight fit pulling over
1/8"-1/4"
to wrap around as recommended. But my real problem came several hours
after
I finished when I notice that the vinyl was splitting in the corners of the
gauge cluster opening. Two of the splits should be covered by the
faceplate
but one will not, I will probably try to section a small sliver of scrap
material into the split to hide as best as I can.
Before I try this again, are there any suggestion that the list can provide
for a smoother application?
Bill B
'58 TR-3A TS/30766 L
'59 TR-3A TS/64974 LO
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as flashtr3@cox.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|