Well, Randall was right.B (Wait, is that a redundancy in terms????)B The
Roadster Factory makes their own ball joint boots.B Can only be better than
what I had.B Ordered four and will install and monitor.
New question:B When I disconnected the ball joints, I seem to have dinged up
the little washer like gizmos that slide off the shaft.B
Do I have to replace the whole ball joint, or can I get along without these?B
It's only the taper on the shaft endB that seats the ball joint, right?
Terry Smith, '59 TR3A
New Hampshire
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|