triumphs
[Top] [All Lists]

[TR] installing a u-joint

To: Triumphs@autox.team.net
Subject: [TR] installing a u-joint
From: "Jim Muller" <jimmuller@rcn.com>
Date: Tue, 17 Jun 2008 14:30:44 -0400
Some advice please.  Are there any tricks to installing a u-joint 
properly without making a total botch of it?  I've done one or two on 
a driveshaft, but I can't say I did them well or even right at all.  
They would not finish moving into place without rather too much 
force, or so it seemed.  (Since the driveshaft needed splines and 
some balancing anyway, I then let a decent driveshaft shop do it 
right.)

Thanks,

Jim Muller
jimmuller@rcn.com
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>