Greetings to everyone from The Deep South in New Zealand.
My turn to ask for help here. My winter project is to install my new
3A rear axle to replace my early style weak axle assy. at long last in
my TR2. I am redoing all the braking system and I need some help with
making the new metal brake lines to run from the wheel cylinders to
the T junction mounted on the new axle. (The lines on my 2^nd.hand
axle have been cut off at the cylinder ends so I have no pattern to
work from.)
Can anyone help provide pictures of the correct routing of the lines
along the axle assy. and round to the cylinders ? (I cannot find good
enough photos in any of my books)
Can anyone tell me the correct length to get the lines made to before
they are bent?
All help would be greatly appreciated.
Kind regards
Alan
TS3512
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|