1962 TR4 with 3 degree trunnions.
I have purchased a kit for the front suspension with new trust washers etc. I
am supposed to torque the new outer trunnion trust washer and the outer washer
onto the trunnion splines at 50lb to serate the outer washer. I am not up to
80lb and only limited success. I think that about 200-300 lb would do it which
scares me.
The old outer washers are are re-usable. Do I slightly drill out the new
washers so that there is less steel to serate.
Any help would be appreciated.
Thanks
Jim and his immobile TR4
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|