well I fixed my front apron. cut the tie bar bracket from the inner wing and
repositioned it. looking good. all dimensions within 1/8" now.
now I'm looking at the gap between the bonnet and the front fender, all
along the sides. someplace's its tight 1/8". other places its horrible 3/4".
I
can make it right. but what's right? or what's nominal?
I don't have the fender bead to play with to figure out how much space it
takes up or if it looks good at say 1/4".
however wide it is, its equally covering both the fender and the apron. when
we get to the bonnet the bigger part of 1/2 of it takes up some of the space
between the bonnet and fender. how much space? what's the fender bead
dimension?
love to hear your dimensions.
also what tricks have you guys pulled to stop the back of the bonnet rubbing
against the cowl when opening? i don't have room to elongate the holes and
move the bonnet forward. too close to the apron already. shim the hinge to
cowl? or ?
thanks
Frank
**************Create a Home Theater Like the Pros. Watch the video on AOL
Home.
(http://home.aol.com/diy/home-improvement-eric-stromer?video=15&ncid=aolhom00030000000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|