Try needle nosed vice grips. A good tight grip and some wiggles back and
forth usually gets them off.
Bud
71TR6 CC57365 (Good 6)
66TR4A CTC57806 (The Wreck-Almost Parts)
66TR4A CTC57529 (The Project)
71F-250 Camper Special (Triumph Support Vehicle)
Z-50A Hardly Davidson 1977 Honda Mini-Trail Bike (Triumph Pit Bike)
----- Original Message -----
From: spit6@kning.com
To: triumphs@autox.team.net
Sent: Thursday, March 06, 2008 12:44 AM
Subject: [TR] Rear Wheel Axles and Front Grease Caps
Dear All,
I've recently been pushed to accelerate my project. J
I've disassembled my project down to the chassis for quite some time. I
was
cleaning up the rear axles and noticed that I can't make them rotate.
They're locked. I've removed the brake lines, does that do anything to
make
them lock? Do I need to repack the grease seal?
I also am trying to replace the front rotors, and I can't remove the grease
caps. Any ideas? I just can't get a grip on it to pull it off.
Appreciate it.
Thanks,
Kelvin
Spit6 Project
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as levilevi@comcast.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|