Thanks. I'll give a try and report back.
John
On Thu, Feb 28, 2008 at 3:24 PM, Randall <tr3driver@ca.rr.com> wrote:
> > I'd like to get the header out for a ceramic coating, but, of
> > course, can't
> > budge it from its junction with the tail pipe. Many applications of
> > rust-bust stuff hasn't helped. Is there a way to get them
> > apart without cutting?
>
> Not always.
>
> > Do I apply a propane torch?
>
> Should help, but don't forget that most "rust bust stuff" is flammable.
> Get
> it good and hot, then try twisting the pipes. Wrapping a wet towel around
> the part that goes inside (to create a temporary thermal gradient) may
> help
> too. Once they start to move a little, dose with PB Blaster then keep
> twisting back and forth.
>
> Randall
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as leejohn7@gmail.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|