I too bought the cheap HF gun, did not have to prime it and have changed
cartridges once. No problems to report, maybe you should take it back for
an exchange before it gets too old.
Good luck,
Bill B
'58 TR-3A TS/30766 L
The car is in a 'zillion' pieces... but I think about it every day!
-----Original Message-----
From: triumphs-bounces+wbeech=flash.net@autox.team.net
[mailto:triumphs-bounces+wbeech=flash.net@autox.team.net] On Behalf Of
Aribert Neumann
Sent: Friday, February 22, 2008 2:18 PM
To: triumphs@autox.team.net
Subject: [TR] Anyone using a Pneumatic grease gun {Scanned}
I bought a pneumatic grease gun - my old workshop lever grease gun finally
failed from being cross threaded once too often. This pneumatic grease gun
is a Chinese special from Harbor Freight. The instructions say that if the
gun does not pump grease to "prime" the gun. So far, I have not had any
luck priming the gun. Anyone out there have one of these cheap pneumatic
grease guns? Did you have a problem getting it to start pumping? Is this
going to be an issue w/ every change in grease cartridge or is this a one
time problem (if this is going to be an every time problem, I'll go back to
the lever style of gun)?
--
This message has been scanned for viruses and dangerous content by
MailScanner, and is believed to be clean.
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as wbeech@flash.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|