To: | "'Triumph car discussion Sports'" <Triumphs@autox.team.net> |
---|---|
Subject: | Re: [TR] remote control master off switch amperage? |
From: | "Randall" <tr3driver@ca.rr.com> |
Date: | Fri, 11 Jan 2008 13:58:51 -0800 |
> How many amps would I > need if the wire is the ground to a relay that allows other > relays to > send current? Depends on the relay (obviously), but a common automotive relay should draw under 0.1 amp. But make sure the module output is a constant "on" when you want the relay on. Some outputs are only momentary. Randall _______________________________________________ Support Team.Net http://www.team.net/donate.html This list supported in part by the Vintage Triumph Register http://www.vtr.org Triumphs@autox.team.net http://autox.team.net/mailman/listinfo/triumphs http://www.team.net/archive |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TR] Off topic, pressure washers, Randall |
---|---|
Next by Date: | Re: [TR] Carefully Cleaning a TR3 Engine Block, Dave1massey |
Previous by Thread: | Re: [TR] remote control master off switch amperage?, 60TR3A |
Next by Thread: | [TR] Carefully Cleaning a TR3 Engine Block, bill beecher |
Indexes: | [Date] [Thread] [Top] [All Lists] |