triumphs
[Top] [All Lists]

Re: [TR] Ride height for a TR4

To: diggle@clear.net.nz, triumphs@autox.team.net
Subject: Re: [TR] Ride height for a TR4
From: DLylis@aol.com
Date: Mon, 3 Dec 2007 08:00:44 EST
I have just replaced all springs on my 3A and the rears did not allow the  
axle to come off it's resting point on the chassis.  There is no body on  the 
car so that weight is not present, however my old springs did allow the axle  
off the chassis with the body off.  I am anticipating that I am going to  have 
the same ride height issue once the body goes on. A couple  of 200 pounders on 
the chassis don't improve  it much either.  I don't  really have a sense as to 
whether or not 400 pounds on the rear chassis  adequately represents a body 
and gas tank, etc.  
If this does prove to be a problem I am prepared to extend the rear spring  
shackles which will lower the chassis relative to the drive train.  What is  
the consensus?  Will this screw up any suspension geometry?  Will  these 
springs 
"wear in"?
 
David  Lylis
69 TR6 CC26160L
60 TR3A TS74461LO



**************************************Check out AOL's list of 2007's hottest 
products.
(http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>